Click Here

Rolleicird V

In this forum you , the user , may be asked for assistance from time to time.

Rolleicird V

Postby Rorymcw » Wed Nov 04, 2015 11:29 am

I am rebuiling a Rolleicord which I bought in bits. Every Single part was taken apart including the escapement and timer. Its all back together and as good as it was the day it left the factory However the person who took it apart drilled out the casing to remove two screws. I will need to weld and redrill and tap the holes. Its the two screws which hold the back on . My qustion is.
What thread did Rollei use. I am assuming it was not metric as the new screws appear to be 1/16 and 5/64 when measured but to order the correct taps I need to know thread type. Do any of you guys know what they used.
Rorymcw
New here
 
Posts: 1
Joined: Mon Sep 14, 2015 1:12 am

Return to User help

Who is online

Users browsing this forum: No registered users and 4 guests