Part for waist level viewfinder

[Analogueworld]

Is there a kind soul out there to help a new member? I've just bought a Rolleiflex T and one of the tiny screws that hold the top cover to the frame is missing. It's countersunk, and the head diameter is approximately 2.5mm. Slotted head. So far I've not even put any film through the camera so its functional condition is unknown but already I'm enjoying owning it! In the absence of the part being available, information on thread size etc would be super-welcome. Thanks in anticipation! Jay

[JanBoettcher]

It should be M1,7 and not really "countersunk".
It should be a rather flat cylindrical head with bevelled top edge (but any M1,7 of fitting length and small enough head should do the job).

Where are you located?

[Analogueworld]

Thanks for that. I noticed they were cheese head after I posted my question. I am located in the UK. I need 2 of the screws. Jay